

Detaliu vizualus vaizdas: greicio daviklis
Šį pranešimą redagavo sukle: 2011 balandžio 06 - 19:46
Parašyta 2011 balandžio 06 - 19:39
Šį pranešimą redagavo sukle: 2011 balandžio 06 - 19:46
Parašyta 2011 balandžio 07 - 08:36
Parašyta 2011 balandžio 07 - 09:24
I have a T-Reg Peugeot 406 HDI 110 GTX, with a flickering speedo.
The speedo seems to control itself under load / acceleration, but flickers up and down otherwise. I have tried the following:
1) Replaced gearbox sensor (Garage)
2) Looked for interface unit behind glovebox (not found)
3) Removed instrument console and re-soldered speedo connections
4) Replaced instrument console with one from breakers, then put back original (after addition of 13,000 miles!)
5) Removed and WD40'd both electrical loom connectors beneath air filter / battery
6) Removed and WD40'd as many relevant connectors in engine bay
Speedo still flickering. Do not know what to do next?
Davros
9 May 2007, 9:47 PM pug1
Joined 22 Jan 2006
560 posts
i had the same problem it turned out to be the bevel drive which is located inside the houseing where the V.S.S vichle speed sensor goes so you will need to remove the drivers side drive shaft and unbolt the V.S.S housing to replace the bevel drive inside (peugeot made them out of plastic lord knows why). its a pig of a j** it took me 2 hrs to replace but it will solve the problem. be gentle when you replace the driveshaft
Parašyta 2011 balandžio 07 - 21:00
Parašyta 2011 balandžio 07 - 21:26
Parašyta 2011 balandžio 08 - 18:34
Trumpam nerodymas/rodymas - dazniausiai kaltas pats daviklis. Padevetas kainuoja 20-30 Lt, naujas ERA ar Valeo firmos - 70 Lt.As kai domejaus del sito daviklio, pugu atstovybej, tai irgi uzsimine, kad gali buti subyrejes pats dantratis greiciu dezej. Itariu tavo atveju ten ir bus problema. Kiek mokejai uz nauja davikli?
Kai pasikeisi ta dantrati informuok kaip sekes ir kiek viskas kastavo, itariu ir man gali taip pat kazkada atsitikt, nes retkarciais uzeina, kad trumpam neberodo greicio.
Parašyta 2011 balandžio 08 - 21:02
Galejo bent vidini dantrati daryti ne plastikini, o dabar tai neisivaizduoju, kaip reikes ardyti viskaman tai keista, kad 2.2 nuo sios bedos labiausiai kencia
![]()
kokios galimos to priezastys? ismetimo kolektorius arti, dugnas uzdarytas, mazu perkaista?
Parašyta 2011 balandžio 11 - 16:26
Parašyta 2011 balandžio 30 - 14:12
Parašyta 2011 balandžio 30 - 14:18
i had a similar problem with my car as well and its a 406 hdi 2000 model.the speedo was doing the same thing until it stopped working.when i took it for a diagnostic the problem was found it to be a crankshaft positioning sensor.this affects the speedo as well as well.try to have a look on it,it might be the speedo sensor thats at faulty or the crankshaft positioning sensor.
Parašyta 2011 gegužės 03 - 18:56
Parašyta 2011 gegužės 04 - 07:02
Parašyta 2011 gegužės 04 - 21:24
Parašyta 2011 gegužės 05 - 10:26
Parašyta 2011 gegužės 16 - 08:57
Parašyta 2011 gegužės 16 - 15:30
narių: 0, svečių: 1, slaptų narių: 0